Beijing Ruiyixing Technology Co., Ltd.ccve365@qq.com·(010) 6053 0441·中文
RyCCVE365Request a quote
Technical articles ·

AC24V or DC12V for CCTV Power: How to Choose

KEY TAKEAWAY

Pick by device nameplate: bullets and domes DC12V, PTZ heads AC24V. At long runs AC24V drops less and reaches farther. Mixed sites use a combined supply.

Two questions come up on almost every CCTV job: should the front end run on AC24V or DC12V? The answer is not a preference — it is fixed by what each device is rated for. This article sets out the rule by device type, explains why AC24V holds up better over distance, and shows how to power a site that mixes both voltage classes.

1. The nameplate decides the voltage

A camera's supply voltage is set by the device itself and cannot be changed on site. The usual split:

Device typeTypical rating
IR bullet camera, dome cameraDC12V
High-speed PTZ dome, pan-tilt unitAC24V (some pan-tilt heads use DC36V)
PoE cameraPower over the network cable (DC48V negotiated, then stepped down at the device)

2. Why PTZ domes mostly use AC24V

The pan-tilt motors inside a high-speed dome are usually AC motors, driven directly from AC24V — the starting torque and speed characteristics suit that supply. Running the same head from DC12V would need an extra inverter, so domes are almost always rated AC24V. Bullet and dome cameras draw little power and have simple circuits, so DC12V is the norm for them.

3. Distance and voltage drop

For a given power level, a higher supply voltage means a lower line current. Line drop follows ΔU = 2·I·L·ρ/S, so a smaller current produces a smaller drop and the circuit can run farther before the voltage at the far end falls out of range. That is why AC24V outperforms DC12V when a dome sits a long way from the rack.

Note: Always check the voltage that actually arrives at the device. Our online voltage-drop calculator works this out for a given cable length, cross-section and load.

4. How to choose

  • Single device type. Match the supply to the nameplate — DC12V for bullets (for example PS-DC1220-1U, 20 A DC12V), AC24V for domes (for example a 2U AC24V 16 A, 10-channel unit).
  • Mixed site. Either use a combined supply with grouped outputs at several voltages, or install a separate DC12V rack and AC24V rack.
  • Single outdoor camera. A wall-mount centralized supply works well (for example a wall-mount DC12V 25 A, 16-channel unit).

5. Frequently asked questions

Can a DC12V device be connected to an AC24V supply?

No — never. The voltage and the current type both have to match. Connecting a DC12V camera to an AC24V output will destroy it.

What is the best approach for a long run?

Raise the supply voltage where the device allows it (AC24V for domes), or bring 220 V AC out to a local point and step it down close to the camera. Both reduce the drop on the low-voltage leg.

Need a model matched to your project?

Send the voltage class, device count and total load — we will confirm the model and the power headroom.

Request a quote