How Many Cameras Can One Centralized Supply Feed?
Size by load, then check channels and cable length. A 100 W unit feeds about 12 six-watt domes at 1.3 headroom; ports are 8/16/32, long runs need a drop check.
"How many cameras will a 100 W supply run?" The answer depends on the actual draw of each camera and on how much headroom you leave. Two rules cover it: calculate from the maximum draw with IR on, then apply a 1.3 factor for inrush.
1. Two numbers to start with
Camera draw. A typical IR bullet or dome is rated DC12V and uses about 3–5 W in daylight, rising to about 6–12 W at night with the IR illuminator on. Always calculate from the maximum figure on the nameplate, not the daytime figure.
Supply rating. This is the power the centralized supply can deliver continuously — commonly 100 W, 150 W, 200 W, 350 W or 500 W — and it is tied to the number of channels and the per-channel current.
2. The formula
Cameras draw an inrush current at switch-on, so in practice the total requirement is multiplied by 1.3 before choosing a supply:
Cameras per supply N = supply rating ÷ (single-camera draw × 1.3), rounded down.
For example, a 100 W supply feeding 6 W domes: N = 100 ÷ (6 × 1.3) ≈ 12.8, so 12 cameras. Without the factor the same figure reads 16 — but if every illuminator switches on together, or the site runs cold in winter, that configuration trips the protection.
Note: 1.3 is the usual engineering factor for camera inrush and supply tolerance. For loads with a bigger start-up surge — electric locks, alarm panels — use 1.5 instead.
3. Worked example
Ten IR domes, nameplate DC12V at 6 W maximum each. What size supply?
- Total draw = 10 × 6 W = 60 W.
- Apply margin: 60 W × 1.3 = 78 W.
- Choose a supply rated at 78 W or more — 100 W covers it; 150 W leaves room for later expansion.
- Check the channel count: ten cameras need at least 10 output channels. If any run is long, verify the drop as described in How far can centralized power reach.
4. Quick-reference table
| Supply rating | 6 W dome | 10 W bullet | 12 W IR camera |
|---|---|---|---|
| 100 W | 12 | 7 | 6 |
| 150 W | 19 | 11 | 9 |
| 200 W | 25 | 15 | 12 |
| 350 W | 44 | 26 | 22 |
| 500 W | 64 | 38 | 32 |
Rule: N = rating ÷ (draw × 1.3), rounded down. The result still has to satisfy "channels ≥ cameras".
5. Channels and distance still apply
Enough power does not by itself mean you can connect that many cameras. Two other limits apply.
Output channels. A supply has a fixed number of independent output ports — 8, 16 or 32. The camera count cannot exceed the channel count. Matching channels to power is covered in Sizing a CCTV power supply.
Run length. How far each circuit reaches is set by voltage drop, not by the supply's total rating. A 1.0 mm² cable feeding a 10 W camera runs roughly 34–40 m; beyond that, use a heavier gauge or change the approach — see How far can centralized power reach.
6. Frequently asked questions
I calculated 16 cameras but the supply trips at ten. Why?
Most likely the calculation used daytime draw. Current rises when the IR illuminator is on, when a pan-tilt head starts, and in low temperatures; contact resistance in connectors and voltage drop along the cable raise the actual current further. Recalculate from the nameplate maximum × 1.3.
Can electric locks or an alarm panel share a supply with cameras?
Yes, but recalculate the total load. Electric locks have a high start-up current (commonly 0.5–1 A), so give them their own channels and use a larger margin factor.
How much headroom is appropriate?
At least 30 % is the usual engineering recommendation. If expansion is already planned, size for the post-expansion camera count now. See How to select a rack-mount power supply.
Data note: Camera draw and lock current figures are common industry nameplate values; confirm against the actual device. The ×1.3 factor is our engineering practice. Products referenced: PS-DC1208-1U (8 channels, 100 W) and PS-DC1241-32 (2U, 32 channels, 500 W).
Need a model matched to your project?
Send the voltage class, device count and total load — we will confirm the model and the power headroom.